GEOPURE 300 is formulated to eliminate scale and reduce
fouling in membrane systems.Geopure 300 is a liquid
antiscalant/dispersant blended to inhibit scale and
disperse colloidal particles in RO membrane separation
systems. Geopure 300 effectively works under condition of
water less than 1,000 ppm hardness level, Silica up to 150
ppm and TDS up to 4,000 ppm). Geopure 300 active with
manganese and iron.
Code - GP0BC03
Packaging - 30 KGS
- Form:Liquid
- Appearance:Clear to Pale Yellow
- Odour:Not Available
- Solubility in water:Complete
- Miscibility with water:Not Available
- pH @ 25ºC:1.0 to 2.0
Checmical Properties:
Dosage:
A typical Geopure 100 dose ranges from 2-10 mg/l.
Injecting:
Best results are achieved when Geopure 100 is
injected upstream of the membrane system and, where
possible, of cartridge filters.
| Excellent | CaCO3 |
| Fair | Silica |
| Fair | Sulphate |
| Adequate | Phosphate |
| Fair | Iron |
| Fair | Colloidal & Slit |
| 1 | pH | 6.5~7.5 |
| 2 | Total dissolved Solids in mg/L | 4,000 |
| 3 | Total hardness as CaCO3 in mg/L | 1000 |
| 4 | Silica as Sio2 in mg/L | 150 |
| 5 | Iron as Fe in mg/L | 0.4 |
| 6 | LSI | +2.0 |
Geopure 300 is formulated to be injected neat. However, if dilution is required, use deionized water or RO permeate. If neither of these is available, softened water may be substituted. The dilution for Geopure 300 should not result in a solution strength of less than 10%. This guideline will protect the effectiveness of the internal bacteriostat, which inhibits bacterial growth in the product packaging and feed tank.
Technical Support (Sales Backup) is available for chemicals selection, dosing, startup assistance, CIP supervision. Troubleshooting and all technical guidance.