GEOPURE 800 is specially formulated for Evaporators to
eliminate scale and reduce fouling in membrane systems.
Geopure 800 is a liquid antiscalant/dispersant blended to
inhibit scale and disperse colloidal particles in RO
membrane separation systems. Geopure 800 effectively works
under stress condition of water. Geopure 800 active with
moderate amounts of silica, manganese and iron
Code - GE0E800
Packaging - 25 KGS
- Form:Liquid
- Appearance:Honey Brown
- Odour:Not Available
- Solubility in water:100%
- Miscibility with water:Not Available
- pH @ 25ºC:5.0 to 7.0 ± 1.0
Chemical Properties:
Dosage:
A typical Geopure 100 dose ranges from 2-10 mg/l.
Injecting:
Best results are achieved when Geopure 100 is
injected upstream of the membrane system and, where
possible, of cartridge filters.
| Excellent | CaCO3 |
| Fair | Silica |
| Fair | Sulphate |
| Adequate | Phosphate |
| Fair | Iron |
| Fair | Colloidal & Slit |
| 1 | pH | 7.5 ~ 8.5 |
| 2 | Total dissolved Solids in mg/L | 15,000 |
| 3 | Total hardness as CaCO3 in mg/L | 3500 |
| 4 | Silica as Sio2 in mg/L | 350 |
| 5 | Iron as Fe in mg/L | 0.7 |
| 6 | LSI | +5.0 |
Geopure 800 is formulated to be injected neat. However, if dilution is required, use deionized water or RO permeate. If neither of these is available, softened water may be substituted. The dilution for Geopure 800 should not result in a solution strength of less than 10%. This guideline will protect the effectiveness of the internal bacteriostat, which inhibits bacterial growth in the product packaging and feed tank.
Technical Support (Sales Backup) is available for chemicals selection, dosing, startup assistance, CIP supervision. Troubleshooting and all technical guidance.